Click Boards
Filter Product By
Slide and select filter/s
Filtered by
Categories
Loading
Load more
Loading
Viewed products
Clock Gen 6 Click is a compact add-on board representing a digital oscillator solution. This board features the MIC1557, an IttyBitty CMOS RC oscillator designed to provide rail-to-rail pulses for precise time delay or frequency generation from Microchip Technology. The MIC1557 has a single threshold and trigger connection, internally connected, for astable (oscillator) operation only. It also has an enable/reset control signal routed to the RST pin of the mikroBUS™ socket, which controls the bias supply to the oscillator’s internal circuitry and optimizes power consumption used for oscillator power ON/OFF purposes. In addition, it provides the ability to select the desired frequency programmed via a digital potentiometer, the MAX5401. This Click board™ is suitable for pulse generation, precision timer, time-delay generation, and similar applications.
MIKROE-4973$14.00
Type Cloud Routers,LTE IoT Applications Can be used for the development of smart homes, industrial automation, health care, consumer electronics, and many more On-board modules SARA-R510AWS - LTE-M AWS IoT EsxpressLink module from u-blox Key Features Direct AWS IoT cloud access secured with hardware-based root of trust, s upports a comprehensive set of 3GPP Rel. 14 features that are relevant for IoT applications, 5G ready upgradable over the software, micro-SIM card, SMA antenna, and more Interface UART,USB ClickID Yes Compatibility mikroBUS Click board size L (57.15 x 25.4 mm) Input Voltage 3.3V or 5V
MIKROE-5927$131.00
Type ADC Applications Can be used for the development of a wide variety of industrial measurements, data acquisition systems, monitoring functions, and more On-board modules AD7124-8 - 24-bit sigma-delta ADC from Analog Devices ADuM341E - 5kVrms quad digital isolator from Analog Devices Key Features Full SPI serial interface isolation, 8 ADC channels, wide output data rate, low RMS noise, three power modes, rail-to-rail analog inputs, diagnostic functions, crosspoint multiplexed analog inputs, 8 differential/15 pseudo differential inputs, programmable gain, and more Interface SPI ClickID Yes Compatibility mikroBUS™ Click board size L (57.15 x 25.4 mm) Input Voltage 3.3V,External
MIKROE-5901$54.00
BroadR-Reach click brings the industry grade communication standard to the mikroBUS™, which is built to be used in an Ethernet-based open network. The click board is equipped with the BCM54811 Transceiver from Broadcom Limited, which is used to provide the hardware PHY layer for the network, and the W3150A+ from WizNet, a hardware LSI protocol stack, that provides an easy and low-cost solution for high-speed Internet connectivity for digital devices by allowing simple installation of TCP/IP stack in the hardware.
MIKROE-2796$83.00
