Temperature & humidity
Filter Product By
Slide and select filter/s
Filtered by
Categories
Loading
Load more
Loading
Viewed products
SHT Click is a compact add-on board for accuracy, high reliability, and long-term stability in humidity and temperature measurements. This board features the SHT31-DIS, a humidity and temperature sensor from Sensirion. Compared to its predecessor (SHT11), SHT Click has increased reliability and enhanced signal processing features with a high signal-to-noise ratio. The SHT31-DIS can measure the relative humidity in the range from 0 up to 100% with a typical accuracy of ±2% and temperature from -40 up to 90°C with a typical accuracy of ±0.3°C. This Click board™ makes the perfect solution for developing humidity and thermal management of portable electronics and industrial, consumer, and environmental applications.
SHT Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-2101$31.00
The USB UART Board is a prototype board that features a USB support with an on-board USB to serial UART interface device FT232RL. There is also a jumper used for selecting VCC output level provided on the board.
MIKROE-483$16.80
IR Click is a compact add-on board representing a compact and easy solution for adding an infrared (IR) remote control to your design. This board features the TSOP38238, a miniaturized sensor for receiving the modulated signal of QEE113 IR emitting diode from Vishay Semiconductors. This IR sensor module consists of a photodetector, pre-amplifier, and automatic gain control to surpass ambient noise with signals transmitted to it in the near-infrared range, tuned to a carrier frequency of 38kHz with a beam and viewing angle of 45 degrees. It also communicates with the target MCU via selectable GPIO lines. This Click board™ is suitable for IR remote control applications that improve your system and allow you more flexibility.
IR Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-1377$11.00
The EasyConnect Board features standard screw-terminated connectors that enable eight wires to be easily connected or removed. These connectors can handle solid and stranded wires.
MIKROE-128$6.00
