Clock & Timing
20%
Filter Product By
Slide and select filter/s
Filtered by
Categories
Loading
Load more
Loading
Viewed products
CEC1302 clicker is an amazingly compact starter development kit which brings click board™ connectivity to the 32-bit ARM® Cortex™-M4 CEC1302 microcontroller with an integrated cryptographic engine. Board features all you need to get started: 32-bit CEC1302 microcontroller, USB-UART connector, two LEDs and push buttons, reset button and headers for interfacing with external electronics.
Hundreds of possibilities with Click boards™. With mikroBUS™ socket, you can take advantage of the huge potential of Click boards™, the constantly expanding range of over 750 add-on Click boards™.
Programming. To make your prototyping experience as convenient as possible, STM32 M4 clicker is preprogrammed with a UART bootloader. Just download our mikroBootloader application and you’re ready to upload your firmware. On-board mikroProg for CEC connector enables programming through external programmer/debugger.
MIKROE-1970$37.60
MINI-M4 for Tiva™ C Series is a small ARM® Cortex™-M4 development board containing Tiva™ C Series TM4C123GH6PM microcontroller. It perfectly fits into a standard DIP40 socket. Board is equipped with 16MHz SMD crystal oscillator, and 32.768KHz crystal which can be used for internal hibernation module. It has reset button and three signal LEDs.
Board comes preprogrammed with fast USB HID bootloader, so no external programmers are needed for development. It operates on 3.3V power supply. On-board voltage regulator allows the board to be powered directly from USB cable.
MIKROE-1595$47.20
dsPIC-Ready4 Board is the best solution for fast and simple development of 28-pin dsPIC30F microcontroller applications (dsPIC30F1010, dsPIC30F2020 etc.). It includes connectors for connecting the dsPICprog with mikroICD in-system stand-alone programmer. These connectors enable you to program microcontrollers without any other additional devices. There are also IDC10 connectors linked to the microcontroller pins provided on the bpard. They enable many peripheral modules to be connected to the board, so you can quickly assemble functional working environment that perfectly suits your needs.
dsPIC-Ready4 Board features a USB to serial UART interface FT232R which simplifies USB to serial designs and reduces external component count by integrating an external EEPROM, USB termination resistors and a clock circuit requiring no external crystal into the device.
MIKROE-452$28.00
