Starter Boards
Filter Product By
Slide and select filter/s
Filtered by
Categories
Loading
Load more
Loading
Viewed products
The MMC Ready Board is a complete development solution for MMC/SD based mass storage devices. It is powered by the PIC18F252 device connected to the memory slot, connection pads and external programmer connector.
MMC/SD Ready Card Board can easily become your fast data acquisition device. Because it has microcontroller on board, it can work as an independent device
This microcontroller is programmed via a 2x5 connector that enables connection with the PICFlash programmer.
MIKROE-545$29.00
Ready for PIC Board is the best solution for fast and simple development of microcontroller applications using 28- and 40-pin PIC MCUs. It comes with PIC18F45K22 connected to 8MHz crystal oscillator. It contains four IDC10 headers for all available microcontroller ports, USB-UART module, prototyping area and a power supply circuit. Board is specially designed to fit into special white plastic casing which is sold separately.
Board comes preprogrammed with fast UART bootloader which eliminates the need for external programmers. Board also supports fast USB 2.0 mikroProg™ programmer with hardware In-Circuit Debugger.
Ready for PIC is fully supported by mikroC, mikroBasic and mikroPascal compilers for PIC. Compilers come with dozens of examples that demonstrate every feature of the board.
On-board power supply regulator is great. It supports dual power supply, for both 5V and 3.3V microcontrollers. It features standard power connector, and screw terminals for even easier connectivity.
MIKROE-766$29.00
PIC clicker is an amazingly compact starter development kit which brings innovative mikroBUS™ host socket to your favorite microcontroller. Board features all you need to get started: PIC18F47J53 microcontroller, USB connector, two LEDs and push buttons, reset button, mikroProg connector and headers for interfacing with external electronics..
Hundreds of possibilities with click boards. With mikroBUS™ socket, you can take advantage of the huge potential of click™ boards, the constantly expanding range of over 300 add-on boards.
Programming. To make your prototyping experience as convenient as possible, PIC clicker is preprogrammed with a USB HID bootloader. Just download our mikroBootloader application and you’re ready to upload your firmware. On-board mikroProg for PIC, dsPIC and PIC32 connector enables programming through external programmer/debugger.
NOTE: If programming with mikroProg for PIC, dsPIC, PIC32, make sure to use mikroProg Suite for PIC 2.29 and above.
MIKROE-1487$19.00
ASLK PRO has been designed for undergraduate engineering students to perform analog lab experiments and provides a cost efficient platform for students to realize almost any analog system using general purpose ICs such as OP-Amps and analog multipliers.
MIKROE-957$199.00
