Development Boards
Filter Product By
Slide and select filter/s
Filtered by
Categories
Loading
Load more
Loading
Viewed products
Air Quality Click is a compact add-on board that can detect the presence of poisonous gases. This board features MQ-135, a polluted gas sensor from Zhengzhou Winsen Electronics Technology. The sensitive material of the MQ135 is SnO2, which reacts with lower conductivity in clean air. When target pollution gas exists, the sensor’s conductivity increases alongside the gas concentration. It is characterized by a high sensitivity to ammonia gas, sulfide, and benzene steam, but also with an extended lifespan providing a corresponding output signal of gas concentration from 10-1000ppm through the analog mikroBUS™ line. This Click board™ is suitable for domestic and industrial gas alarms and portable gas detectors.
Air Quality Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-1630$20.00
SPI Isolator Click is a compact add-on board with a digital isolator optimized for a serial peripheral interface. This board features the ADuM4154, a 5kV digital isolator optimized for a serial peripheral interface (SPI) from Analog Devices. Based on the iCoupler® chip scale transformer technology, the low propagation delay and jitter in the SCLK, SI, SO, and SSS SPI bus signals support SPI clock rates of up to 17MHz.It also provides a slave select multiplexing system that allows up to four slave devices to be serviced from one isolator. When a target slave is selected, the slave select signal propagates to the desired output with low propagation delay, allowing tight timing control. This Click board™ is suitable for general SPI-bus isolation, industrial automation systems, sensor isolation, and many other applications.
SPI Isolator Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-2583$35.00
Hall Switch 2 Click is a compact add-on board that represents a magnetic field-activated dual-relay Click board™. This board features the MHA100KN, a high-performance, low-power Hall-Effect sensor from MEMSIC. This Hall switch is a fully integrated CMOS IC that outputs a high-low signal following magnetic field changing. It works with a magnet and detects the magnet's close/away position. Two high-quality compact relays allow switching of high voltages and can cut or establish a connection on the main side of the circuit. This Click board™ is suitable for various applications activated by the magnetic field, such as contactless switches, lids or tray position detecting switches, or other similar applications that require contactless switching of the relay contacts.
Hall Switch 2 Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-4788$32.00
Lithium Battery CR2032 is a non-rechargeable (primary) coin-cell battery utilizing lithium chemistry, which is very common today and used in many applications. It offers long-lasting, reliable power for various devices providing a high voltage of 3V. It is characterized by a very low self-discharge and long shelf life (up to 10 years), alongside its usefulness in a wide range of temperatures (from -20°C up to +60°C). This battery represents the best solution for adding an autonomous and stable power supply to your devices that require mobility and a steady energy source.
MIKROE-5267$2.28
