Brushed
Filter Product By
Slide and select filter/s
Filtered by
Categories
Loading
Load more
Loading
Viewed products
Battery Holder for CR2032 represents a unique battery holder (SN2032) that allows you to maintain good contact with the battery and facilitates simple replacement. This battery holder is suitable for a non-rechargeable (primary) coin-cell battery, CR2032 lithium coin cell battery (20mm diameter x 3.2mm thickness). The SN2032 comes with three mounting pads for direct soldering on the PCB, which turns it into an easy-to-connect solution perfect for devices with a voltage of 3V and a capacity of 210mAh.
NOTE:This battery holder can also be found in an embedded format in combination with the RTC 2 Click board™. For more information about this Click board™, visit the RTC 2 Click product page.
MIKROE-5518$1.80
DC Motor 6 Click is a PWM chopper type brushed DC motor driver, labeled as TB67H451AFNG, produced by Toshiba. This IC includes one channel of motor output block, using a wide range of supply voltages, while delivering reasonably high current to the connected DC motors. Low ON-resistance MOSFETs and a PWM control help the TB67H451AFNG exhibit lower heat generation thus efficient motor drive. Furthermore, the TB67H451AFNG has two inputs, IN1 and IN2, which allow for selection of the four operation modes; forward (clockwise), reverse (counter-clockwise), short brake, and stop modes.
DC Motor 6 Click board™ is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-4114$14.00
