Filter Product By
Slide and select filter/s
Filtered by
Categories
Loading
Load more
Loading
Viewed products
AMR Angle Click is a compact add-on board containing an anisotropic magnetoresistive measurement solution ideal for either angle or linear position measurements. This board features the ADA4571, an AMR sensor with clean and amplified cosine and sine output signals related to a rotating magnetic field angle from Analog Devices. It can provide better than 0.2° angular accuracy over 180°, and linear accuracy of 2mil (0.002 inches) over a 0.5-inch range, depending on the size of the used magnet. This Click board™ is suitable for absolute position measurement (linear and angle), contactless angular measurement and detection, magnetic angular position sensing, actuator control and positioning, and more.
AMR Angle Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-4561$38.00
CC3100 Click is a compact add-on board that sends and receives data over Wi-Fi. This board features the CC3100, a Wi-Fi 802.11b/g SimpleLink™ series network processor from Texas Instruments. The TI’s SimpleLink™ is a platform with industry-leading features, including low power and robustness, and integrates security support with more than ten differentiated wired and wireless protocols. The CC3000 comes with an embedded IPv4 TCP/IP stack and is a complete platform solution with high TX power and RX sensitivity, which makes it one of the best-in-class radio performances. This Click board™ is suitable for industrial wireless control, smart home applications, and adding simple wireless communication capabilities to your design.
CC3000 Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-2336$59.00
SPI Isolator Click is a compact add-on board with a digital isolator optimized for a serial peripheral interface. This board features the ADuM4154, a 5kV digital isolator optimized for a serial peripheral interface (SPI) from Analog Devices. Based on the iCoupler® chip scale transformer technology, the low propagation delay and jitter in the SCLK, SI, SO, and SSS SPI bus signals support SPI clock rates of up to 17MHz.It also provides a slave select multiplexing system that allows up to four slave devices to be serviced from one isolator. When a target slave is selected, the slave select signal propagates to the desired output with low propagation delay, allowing tight timing control. This Click board™ is suitable for general SPI-bus isolation, industrial automation systems, sensor isolation, and many other applications.
SPI Isolator Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-2583$35.00
LEM Click is a compact add-on board that can measure AC and DC currents with exceptional speeds of up to 300KHz. This board features the LTS 6-NP, a current transducer from Lem. Considering the AC and DC currents, it is intended for the electronic measurement of pulsed, mixed with galvanic separation between the primary and the secondary circuits. The transducer comes in a compact design and insulating plastic case and has high immunity to external interferences. This Click board™ makes the perfect solution for the development of applications based on AC variable drives, servo motor control, power supplies, static converters for DC motor drives, and more.
LEM Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-2553$52.00
