Clock & Timing
Filter Product By
Slide and select filter/s
Filtered by
Categories
Loading
Load more
Loading
Viewed products
4-20mA R Click is a compact add-on board that serves as a receiver in a 4-20mA current loop standard. This board features INA196, a current shunt monitor from Texas Instruments. The INA196 can sense drops across the shunt at common-mode voltages from -16V up to +80V, independent of its supply voltage. Thanks to the boost converter, high input voltages necessary for proper operation are achieved, with its analog data processed via the onboard A/D converter SPI interface. Together with 4-20mA T Click, this Click board™ forms a complete 4-to-20mA current loop standard suitable for industrial process control, test systems, and more.
4-20mA R Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-1387$37.00
MPU 9DOF Click is a compact add-on board that contains a 9-axis inertial measurement unit. This board features InvenSense’s MPU-9250, a multi-chip module (MCM) consisting of a 3-axis MEMS gyroscope, accelerometer, and magnetometer with three 16-bit ADCs and signal conditioning unit. For precision tracking of both fast and slow motions, the MPU-9250 features a user-programmable full-scale gyroscope range of ±250, ±500, ±1000, and ±2000dps, accelerometer range of ±2g, ±4g, ±8g, and ±16g, and a magnetometer range of ±4800μT, alongside a configurable host interface that supports both SPI and I2C serial communication. This Click board™ is suitable for consumer electronics equipment such as angle measurements, motion detection, gesture position, or as a pedometer.
MPU 9DOF Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-1719$45.00
BroadR-Reach click brings the industry grade communication standard to the mikroBUS™, which is built to be used in an Ethernet-based open network. The click board is equipped with the BCM54811 Transceiver from Broadcom Limited, which is used to provide the hardware PHY layer for the network, and the W3150A+ from WizNet, a hardware LSI protocol stack, that provides an easy and low-cost solution for high-speed Internet connectivity for digital devices by allowing simple installation of TCP/IP stack in the hardware.
MIKROE-2796$83.00
MIKROE-1160$118.80
