Click Boards
Filter Product By
Slide and select filter/s
Filtered by
Categories
Loading
Load more
Loading
Viewed products
EEPROM 4 click is 2,097,152 bits on a click board™, organized into 262,144 bytes. In other words, this click board™ is an EEPROM memory medium with the capacity of 256 KB. The used EEPROM module has very good endurance and it can withstand 1,000,000 write cycles, with the data retaining period of about 40 years. The EEPROM module on this click can work with power supply voltage ranging from 1.7V to 5.5V, it features the self-timed write cycles, doesn’t require erase before writing, has a dedicated write protect pin for hardware protection of stored data, and has a dedicated hold pin used for holding the data transfer.
MIKROE-2536$18.00
Hall Switch click is a magnetic field activated dual-relay Click board™. Hall Switch click has two high-quality relays, which are activated by the Hall-effect sensor: when the north pole magnetic field is introduced to the sensor, one of the relays will be activated; when the south pole magnetic field is introduced to the sensor, the other relay will be activated. Two high-quality compact relays allow switching of high voltages - up to 220V, so they can cut or establish a connection on the main side of the circuit.
MIKROE-2985$22.00
USB I2C Click is a compact add-on board that provides a general-purpose USB to I2C/UART serial interface conversion. This board features the MCP2221A, a USB 2.0 to I2C/UART protocol converter with additional GPIO functionality from Microchip. This Click board™ features Communication Devices Class (CDC) for USB-to-UART conversion and Human Interface Device (HID) for I2C device control and configuration. Besides full-speed USB (12Mbps), the MCP2221A also supports I2C with up to 400KHz clock rates and UART baud rates up to 460800. All three major operating systems, like Windows, Linux, or MacOS, are connected via a mini-USB connector and are supported by Microchip’s configuration utility. This Click board™ makes the perfect solution for adding a USB to UART or I2C conversion to your application.
USB to I2C Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-1985$17.00
MIKROE-4570$3.99
