Sensors
Filter Product By
Slide and select filter/s
Filtered by
Categories
Loading
Load more
Loading
Viewed products
Ozone 2 click is an Ozone detection (O3) sensor, based on the MQ131 gas sensor. This gas sensor has a sensitive layer made of SnO2, which changes its resistance when exposed to ozone. The sensor is able to sense O3 concentration in the range of 10 ppm to 1000 ppm. The Click board™ is also equipped with a trimmer potentiometer, used to adjust the sensitivity and offset of the MQ131 sensor. Low cross-influence of other oxidation gases such as CL2 and NO2, ensures a good accuracy of the sensor. The analog output of the sensor is sampled by a high-resolution 22-bit A/D converter (ADC), which offers the conversion result on the SPI interface. The analog signal from the sensor is also available, allowing an external ADC to be used.
MIKROE-2767$54.00
BT Audio 3 Click is a compact add-on board with high-performing voice and audio post-processing capability for Bluetooth audio applications. This board features the BM83, a fully certified Bluetooth v5.0 stereo audio module from Microchip. The BM83 contains an onboard Bluetooth stack and audio profiles and supports 24-bit/96 kHz high-resolution audio formats to enable high-fidelity wireless audio. An integrated Digital Signal Processor (DSP) decodes AAC and SBC codecs and executes advanced audio and voice processing such as Wide-Band (WB) speech, Acoustic Echo Cancellation (AEC), and Noise Reduction (NR). Configured in Host mode, the BM83 allows data processing via the UART interface, and in addition, comes with many additional features such as audio control buttons, onboard microphones, LED indicators, and more. This Click board™ is suitable for Bluetooth audio applications, more precisely, for a smartphone (source) streaming audio to a speaker.
BT Audio 3 Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-4947$54.00
mikroProg for PSoC 5LP is a fast programmer and hardware debugger based on Miniprog from Infineon. It supports all PSoC 5LP microcontrollers with ARM® Cortex™-M3 core.
MIKROE-1449$169.00
FM Click is a compact add-on board that provides an FM radio tuner with any MCU. This board features the Si4703, a broadcast FM radio tuner for portable applications from Silicon Labs. The Si4703 supports a worldwide FM band of 76-108MHz, with an integrated digital low-IF receiver, frequency synthesizer with VCO, seek tunning, automatic frequency control (AFC), automatic gain control (AGC), volume control, RDS/RBDS processor, RSSI readings, and more. The board features two LM4864 audio amplifiers from Texas Instruments for both output channels and a stereo audio connector, where the headphones act as an FM radio antenna. This Click board™ makes the perfect solution for MP3 players, portable radios, PDAs, and more.
FM Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-1431$35.00
