0 item/s in cart
Filter Product By
Slide and select filter/s
LEM click carries the LTS 6-NP current transducer and MCP3201 ADC converter. The click can measure AC and DC current with exceptional speed, up to 200 KHz. LEM click is designed to run on either 3.3V or 5V power supply. It communicates with the target microcontroller over SPI interface, or directly with analog output.
ADC 5 click is a Click board™ used to sample an analog voltage on the input and convert it to a digital information. ADC 5 click is equipped with the ADC121S021, a low power, single channel 12-bit CMOS analog to digital converter (ADC), with a high-speed serial interface. This device uses the SAR algorithm for sampling the input voltage which, coupled with relatively high bit depth, gives a pretty accurate digital reconstruction of the input voltage. The main feature of this ADC device is its continuous reliability over a wide range of sample rates. The functional specifications are maintained in the range from 50kSPS up to 200kSPS. It performs according to specification over the whole range, maintaining a good linearity and high signal to noise ratio up to 72dB, typical.
4-20mA R Click is an add-on board in mikroBUS form factor which serves as a receiver in a 4-20mA current loop standard. It features INA196 current shunt monitor, MCP3201 12-bit ADC as well as TPS61041 DC/DC boost converter.