OFF
MIKROE-1526
38 g
Status:
DC MOTOR click is a DC motor driver board in mikroBUS form factor. It features the DRV8833RTYH-Bridge motor driver, 74HC4053 multiplexer and two screw terminals.
This product is no longer in stock
Availability date:
DC MOTOR click is a DC motor driver board in mikroBUS form factor. It features the DRV8833RTYH-Bridge motor driver, 74HC4053 multiplexer and two screw terminals. The 74HC4053 IC is incorporated into the design in order to run the motor with only one PWM line available on the mikroBUS™ socket. DC MOTOR click communicates with the target board via SELECT1, SELECT2 and nSLEEP control lines, PWM input line and nFAULT feedback line. The board is designed to use 3.3V or 5V power supplies. It can be powered either from the mikroBUS socket or externally through CN2 terminals. It is limited to a 0.9A driving current with 0.22O current sense resistor. The motor is connected to CN1 screw terminal.
| Type | Brushed |
| Applications | Board is designed as a full H-bridge driver for the DC motor |
| On-board modules | DRV8833RTY H-Bridge motor driver, 74HC4053 multiplexer and two screw terminals |
| Key Features | RED LED indicates active nFAULT line (in case of short-circuit). Full H-bridge driven by a single PWM signal |
| Interface | GPIO,PWM |
| Compatibility | mikroBUS |
| Click board size | L (57.15 x 25.4 mm) |
| Input Voltage | 3.3V or 5V |
NOTE: Please be advised that any peripheral devices or accessories shown connected to the Click board™ are not included in the package. Check their availability in our shop or in the YMAN section below.
$299.00
$449.00
$349.00
$349.00
$349.00
$299.00
$269.00
$249.00
$209.00
$155.00
$221.00
$35.00
$119.00
$419.00
$369.00
