OFF
MIKROE-1911
34 g
Status:
DC MOTOR 2 click carries the TB6593FNG driver IC for direct current motors. With two pairs of screw terminals (power supply and outputs), the click board can drive motors with voltages from 2.5 to 13V
This product is no longer in stock
Availability date:
DC MOTOR 2 click carries the TB6593FNG driver IC for direct current motors, from Toshiba. With two pairs of screw terminals (power supply and outputs), the click board can drive motors with voltages from 2.5 to 13V (output current of up to 1 amps with peaks up to 3.2 amps) . The PWM signal drives the motor while the IN1 and IN2 pins provide binary direction signals that set the direction of the motor (clockwise or counter clockwise), or apply stop or short brake functions. Stop mode cuts off the power supply so the motor continues spinning until it runs out of momentum. Short break brings it to an abrupt stop.
| Type | Brushed |
| Applications | Full H-bridge driver for DC Motors with relatively higher voltage requirements |
| On-board modules | TB6593FNG driver IC for direct current motors |
| Key Features | Drives motors from 2.5 to 13V |
| Interface | GPIO,PWM |
| Compatibility | mikroBUS |
| Click board size | M (42.9 x 25.4 mm) |
| Input Voltage | 3.3V or 5V |
NOTE: Please be advised that any peripheral devices or accessories shown connected to the Click board™ are not included in the package. Check their availability in our shop or in the YMAN section below.
$299.00
$449.00
$349.00
$349.00
$349.00
$299.00
$269.00
$249.00
$209.00
$155.00
$221.00
$35.00
$119.00
$419.00
$369.00
