Filter Product By
Slide and select filter/s
Filtered by
Expand Click is a compact add-on board providing general-purpose I/O expansion. This board features the MCP23S17, a 16-bit resolution I/O expander with the serial interface from Microchip. Any of the sixteen I/Os of the MCP23017 can be configured as an input or output by writing to the configuration register. It also features an interrupt feature,...
DAC Click is a compact add-on board with a fully-featured, highly accurate digital-to-analog converter. This board features the MCP4921, a 12-bit DAC with an SPI interface from Microchip. The MCP4921 has a rail-to-rail output, low power consumption, and fast setting time over a single channel. The DAC Click also has the MCP1541, a 4.096V voltage reference...
MP3 Click is a compact add-on board that allows you to play various audio formats on your audio playback system. This board features the VS1053, an Ogg Vorbis, MP3, AAC, WMA, FLAC, and MIDI audio codec chip from VLSI Solution. The MP3 Click features two 3.5mm audio connectors, one for stereo headphones decoding the audio, and one for a microphone, as the...
DIGI POT Click is a compact add-on board with a digitally controlled potentiometer. This board features the MCP4161, an 8-bit single SPI digital POT with non-volatile memory from Microchip. It is designed to operate as a variable resistor for analog signals with the voltage range of single-supply operation. The MCP4161 in 8-bit resistor network resolution...
microSD Click is a compact add-on board that lets you interface a microSD card with your application. This board features a microSD card slot for microSD cards used as a mass storage medium for portable devices. It is intended for use with standard microSD, removable miniaturized Secure Digital flash memory cards. The other term for those cards is...
ADC Click is a compact add-on board that converts an analog voltage into a digital representation. This board features the MCP3204, a 4-channel 12-bit A/D converter with SPI serial interface from Microchip. The MCP3204 is specified for a maximum conversion of up to 100ksps as a throughput rate. Its SAR architecture is based on a successive approximation...
RS485 Click 5V is a compact add-on board that can be used as an interface between the TTL level UART and the RS422/485 communication bus. This board features the ADM485, a low-power EIA RS-485 transceiver from Analog Devices. It features a half-duplex communication capability, bus Idle, open and short-circuit detection, thermal shutdown, and more. It is...
GPS Click is a compact add-on board representing a compact solution for adding GPS functionality to your device. This board features the LEA-6S, a high-performance position engine module from u-blox. It is designed for low power consumption and low cost and can operate independently as a standalone GPS tracker. Data can also be acquired through a PC...
Build your own programmable timer relays using Ready for PIC, Keypad 4x4 board with EasyPull, RTC, Relay 4 and LCD 2x16 character display with adapter. Just load the demonstration project code and your device is ready to control 4 separate relays.
Note: This sensor is not recommended for new design. This product is obsolete. BlueTooth 2 Stick Board offers low power, highly economic wireless capability to your products. On-board WT41 offers impressive 1000 meters range between two bluetooth modules. It uses easy and simple UART protocol for communication.
100-pin LV-32MX v6 TQFP MCU Cards with PIC32 microcontrollers in TQFP package soldered on them. These cards are compatible with our LV-32MX v6 development systems.
80-pin MCU card with PIC24FJ96GA008
We would like to provide our customers with extra MCUs for development purposes.
Empty 64- and 100-pin PIC32 MCU Cards have a very good contact with the board via a two-line connector.
Empty 64- and 100-pin PIC32 MCU Cards have a very good contact with the board via a two-line connector.
Empty 64- and 100-pin PIC32 MCU Cards have a very good contact with the board via a two-line connector.
BIGdsPIC6 80-pin TQFP 1 MCU Card Empty PCB
The 80-pin TQFP MCU Card comes with the dsPIC30F microcontroller in TQFP package soldered on it.
The EasyLV-18F v6 development system supports 40-, 28- and 20-pin PIC18J and PIC18K microcontroller families from Microchip. It comes with a PIC18F45K20. The system features a USB 2.0 programmer with mikroICD and many peripheral modules such as Serial RAM, EEPROM, COG Display, etc.
Empty 64 and 100-pin LV-32MX v6 MCU Cards that enable you to solder PIC32 microcontrollers in TQFP package and other electronic components you need on them.
100-pin LV-32MX v6 TQFP MCU Cards with PIC32 microcontrollers in TQFP package soldered on them. These cards are compatible with our LV-32MX v6 development systems.
The LV 24-33 v6 is a development system that supports 44-, 64-, 80- and 100-pin PIC24F, PIC24H and dsPIC33F MCUs. It comes with a PIC24FJ128GA010. It features a USB 2.0 programmer with mikroICD (In-Circuit Debugger), touch panel controller, MMC/SD card slot, etc.
Loading
Load more
Loading
