How to configure 3 channels PWM (motor control)?

General discussion on mikroC for dsPIC30/33 and PIC24.
Post Reply
Author
Message
freewheel
Posts: 17
Joined: 01 Oct 2008 10:36

How to configure 3 channels PWM (motor control)?

#1 Post by freewheel » 25 Dec 2008 05:08

Hi,
I have the following:

Pwm_Mc_Init(2*5000, 0x77, 0x0F, 0);

in order to configure 3 channels PWM (for Motor control) with Center Aligned Mode. But it don't work!!!
So can anyone tell me where it wrong?
Top
dane.radakovic
mikroElektronika team
Posts: 95
Joined: 04 Dec 2008 14:19

#2 Post by dane.radakovic » 25 Dec 2008 10:37

Hi,

Please post this question on our Support Desk:
http://www.mikroe.com/en/support/
And provide us with piece of code which demonstrate problem.
Also explain your problem as much you can.

Regards
Top
Post Reply

Return to “mikroC for dsPIC30/33 and PIC24 General”