Filter Product By
Slide and select filter/s
Filtered by
Empty 64- and 100-pin PIC32 MCU Cards have a very good contact with the board via a two-line connector.
Empty 64- and 100-pin PIC32 MCU Cards have a very good contact with the board via a two-line connector.
Empty 64- and 100-pin PIC32 MCU Cards have a very good contact with the board via a two-line connector.
BIGdsPIC6 80-pin TQFP 1 MCU Card Empty PCB
The 80-pin TQFP MCU Card comes with the dsPIC30F microcontroller in TQFP package soldered on it.
The EasyLV-18F v6 development system supports 40-, 28- and 20-pin PIC18J and PIC18K microcontroller families from Microchip. It comes with a PIC18F45K20. The system features a USB 2.0 programmer with mikroICD and many peripheral modules such as Serial RAM, EEPROM, COG Display, etc.
Empty 64 and 100-pin LV-32MX v6 MCU Cards that enable you to solder PIC32 microcontrollers in TQFP package and other electronic components you need on them.
100-pin LV-32MX v6 TQFP MCU Cards with PIC32 microcontrollers in TQFP package soldered on them. These cards are compatible with our LV-32MX v6 development systems.
The LV 24-33 v6 is a development system that supports 44-, 64-, 80- and 100-pin PIC24F, PIC24H and dsPIC33F MCUs. It comes with a PIC24FJ128GA010. It features a USB 2.0 programmer with mikroICD (In-Circuit Debugger), touch panel controller, MMC/SD card slot, etc.
The SHT1X PROTO Board is used to connect your prototype device with a temperature/humidity sensor. It features the SHT11 sensor that uses a 2-wire serial interface, thus enabling you to measure temperature and humidity. Note: not recommended for new design.
The BIGAVR6 development system supports 64- and 100-pin AVR microcontrollers. It comes with the ATMEGA128 microcontroller. The system features a USB 2.0 programmer and many peripheral modules such as touch panel controller, CAN, RTC etc.
Loading
Load more
Loading
