Filter Product By
Slide and select filter/s
Filtered by
MP3 Click is a compact add-on board that allows you to play various audio formats on your audio playback system. This board features the VS1053, an Ogg Vorbis, MP3, AAC, WMA, FLAC, and MIDI audio codec chip from VLSI Solution. The MP3 Click features two 3.5mm audio connectors, one for stereo headphones decoding the audio, and one for a microphone, as the...
DIGI POT Click is a compact add-on board with a digitally controlled potentiometer. This board features the MCP4161, an 8-bit single SPI digital POT with non-volatile memory from Microchip. It is designed to operate as a variable resistor for analog signals with the voltage range of single-supply operation. The MCP4161 in 8-bit resistor network resolution...
microSD Click is a compact add-on board that lets you interface a microSD card with your application. This board features a microSD card slot for microSD cards used as a mass storage medium for portable devices. It is intended for use with standard microSD, removable miniaturized Secure Digital flash memory cards. The other term for those cards is...
ADC Click is a compact add-on board that converts an analog voltage into a digital representation. This board features the MCP3204, a 4-channel 12-bit A/D converter with SPI serial interface from Microchip. The MCP3204 is specified for a maximum conversion of up to 100ksps as a throughput rate. Its SAR architecture is based on a successive approximation...
RS485 Click 5V is a compact add-on board that can be used as an interface between the TTL level UART and the RS422/485 communication bus. This board features the ADM485, a low-power EIA RS-485 transceiver from Analog Devices. It features a half-duplex communication capability, bus Idle, open and short-circuit detection, thermal shutdown, and more. It is...
GPS Click is a compact add-on board representing a compact solution for adding GPS functionality to your device. This board features the LEA-6S, a high-performance position engine module from u-blox. It is designed for low power consumption and low cost and can operate independently as a standalone GPS tracker. Data can also be acquired through a PC...
Build your own programmable timer relays using Ready for PIC, Keypad 4x4 board with EasyPull, RTC, Relay 4 and LCD 2x16 character display with adapter. Just load the demonstration project code and your device is ready to control 4 separate relays.
Note: This sensor is not recommended for new design. This product is obsolete. BlueTooth 2 Stick Board offers low power, highly economic wireless capability to your products. On-board WT41 offers impressive 1000 meters range between two bluetooth modules. It uses easy and simple UART protocol for communication.
100-pin LV-32MX v6 TQFP MCU Cards with PIC32 microcontrollers in TQFP package soldered on them. These cards are compatible with our LV-32MX v6 development systems.
80-pin MCU card with PIC24FJ96GA008
We would like to provide our customers with extra MCUs for development purposes.
Loading
Load more
Loading
