Build your own programmable timer relays using Ready for PIC, Keypad 4x4 board with EasyPull, RTC, Relay 4 and LCD 2x16 character display with adapter. Just load the demonstration project code and your device is ready to control 4 separate relays.
This product is no longer in stock
Following AVR version, we present your with PIC version of Programmable relay timers project. We have created a demonstrational software for all of our PIC compilers and prepared a special project kit which you can use to build your own programmable relay timers under a minute. Just connect Ready for PIC, Keypad 4x4 board with EasyPull, RTC, Relay 4 and LCD 2x16 character display with adapter and load demonstration project code and your device is ready to rock! It can control 4 separate relays.
The LCD Adapter Board is an effective and low-cost board used to connect your development board or prototype device to an LCD. There is an IDC10 connector as well as a potentiometer for LCD contrast adjustment provided on the board.
The LCD display Module is built in a LSI controller, the controller has two 8-bit registers, an instruction register (IR) and a data register (DR). The IR stores instruction codes, such as display clear and cursor shift, and address information for display data RAM (DDRAM) and character generator (CGRAM). The IR can only be written from the MPU. The DR...
The Relay4 Board is small-sized board with 4 Relays (each supports currents up to 16A). Also, it contains ULN2804 (high-current Darlington arrays) for relays driving and IDC10 connector for easier connecting with development or prototype board.
Ready for PIC Ready for PIC Board is the best solution for fast and simple development of microcontroller applications using 28- and 40-pin PIC MCUs. It comes with PIC18F45K22 connected to 8MHz crystal oscillator. It contains four IDC10 headers for all available microcontroller ports, USB-UART module, prototyping area and a power supply circuit. Board is...