STM32CUBE integrated in the workflow ?
-
- Posts: 6
- Joined: 15 Feb 2019 22:42
Re: STM32CUBE integrated in the workflow ?
+100 for intigration from Cube MX
-
- Posts: 25
- Joined: 25 Sep 2010 16:21
Re: STM32CUBE integrated in the workflow ?
Hi,
I try to program clicker 4 for STM32F767BI with STM32CubeIDE but I'm unable to program the Chip. The chip is recognised, some banks are readable but the option bits RDB are FF and must be AA, Erase the complete chip is also impossible. Default, Boot0 on the board is High but if I put it low, same problem. I connect via SWD or JTAG with ST-Link. Also the STM32 is not in the USB device list. We make a lot of nice complicated projects with clickboards, always succeed but STM is ...
I still have no C compiler running on Linux from Mikoe and that's the reason for the moment to use STM32Cube..
Thanks for advice
I try to program clicker 4 for STM32F767BI with STM32CubeIDE but I'm unable to program the Chip. The chip is recognised, some banks are readable but the option bits RDB are FF and must be AA, Erase the complete chip is also impossible. Default, Boot0 on the board is High but if I put it low, same problem. I connect via SWD or JTAG with ST-Link. Also the STM32 is not in the USB device list. We make a lot of nice complicated projects with clickboards, always succeed but STM is ...
I still have no C compiler running on Linux from Mikoe and that's the reason for the moment to use STM32Cube..
Thanks for advice
- Attachments
-
- Screenshot from 2021-05-31 10-59-28.png (276.94 KiB) Viewed 2348 times
-
- Posts: 25
- Joined: 25 Sep 2010 16:21
Re: STM32CUBE integrated in the workflow ?
Problem solved. The wire between the clicker4 and the ST-Link is only 8 cm long but gives a lot of crosstalk . Put the programmer clock to 5 kHz and it works fine.
Mikroe compiler is on my wishlist.
Mikroe compiler is on my wishlist.
Re: STM32CUBE integrated in the workflow ?
Hi,
I'm glad that you have solved this!
Regards,
Filip.
I'm glad that you have solved this!
Regards,
Filip.