CodeGrip cannot find device on EasyPIC v8

[blysynski]

Hello,
I'm having problems with CodeGrip/EasyPIC v8; CodeGrip is showing a red wifi icon (link blocked), I can't detect the target.  Yesterday I was able to connect and program but verify failed every time - the target ran as expected (i.e. successful).

• What can I do to determine what is causing the block? 

• Is there a self test for the EasyPIC board?

[blysynski]

Additional information:
direct connect via USB;

• connection to device is intermittent, multiple attempts to detect device before successful

• CodeGrip will lose target during programming/after programming

• multiple attempt to erase target

[filip]

Hi,

I apologize for this issue, both USB and WiFi programming options are not working ?
Can you tell me is the board recognized in the CODEGRIP Suite when you press Scanning ?

Regards,
Filip.

[fastbike]

I also have a similar problem. I have tried to detect the default chip that comes with the EasyPic v8 - a PIC18F47K42

Here is the screen shot - I get the message "Target is not detected" even though the board is connected via USB

I'm finding this software and board completely unusable, and have wasted hours trying to get a simple thing working

NB: I have downgraded the firmware to v1.3 and the Suite to 1.3.1 because I need to use it with mikroPascal and version 1.4 and above are not compatible, I'm told.

[fastbike]

Fixed it. The low voltage programming mode does NOT work. Try one of the other modes