How to use Codegrip with Nucleo dev. boards?

[dibor]

Hello.
Anybody use this programmer/debugger with Nucleo?
Maybe ME team has any small info/manual?

Best Wishes.

[filip]

Hi,

You should be able to connect it via the SWD connector, just make sure that it matches the pinout of the CODEGRIP,

Regards,
Filip.

[dibor]

You should be able to connect it via the SWD connector.

Hi.
I know about it.
But I thought maybe you are have any diagram godegrip to Nucleo board connection.

[filip]

Hi,

I can make a simple pin to pin drawing if you don't manage to connect it properly.

Regards,
Filip.

[dibor]

Hello Filip.
Please do pin to pin drawing .
I have use everytime integrated ST-link, and now have WiFi Codegrip.
I know where to connect SWCLK and SWDIO and of course GND, but i need to connect reset and VCC.
VCC I can get from pin 1 of CN2.
Do I need to connect reset signal??

Nucleo_board_external_programmer.PNG (223.68 KiB) Viewed 2458 times

Best Wishes.

[dibor]

Hello Filip.
Any response?

[dibor]

Hi,

I can make a simple pin to pin drawing if you don't manage to connect it properly.

Regards,
Filip.

Excellent support!
Two months is over but do not saw any a draw or answer.

[dibor]

Filip, where a simple drawing?
U promise to do it 1.5 years ago.