Error Starting Debugger -PIC Clock Error

[Alexmouse]

I'm using the EasyPIC Fusion v7 with the PIC32MZ2048EFH144 processor board.

If I select "ICD Debug" mode, I can program, but when I try to open the debugger I get errors,
"Error in call to Device driver", and then "mikroICD:-Error Starting Debugger -PIC Clock Error".

I'm powering via the USB, and have enabled target power.
I've tried 80MHz and 200MHz processor clock values.

What am I doing wrong?

[lana.arsic]

Hi,

I'm sorry, but I couldn't reproduce the same behavior,
that error refers to issue with settings in Edit Project.

You can try to use one of preloaded schemes, Project -> Edit Project -> Load Scheme
and choose, for example, P32MZ2048EFH_PLL_24_to_200MHz.cfgsch
and set Frequency to 200 MHz.

Kind regards,
Lana

[Alexmouse]

Yes, loading this scheme is better, I can now enter Debug. I'd hoped to have found a step by step guide which would have explained this step to me.
I'm not getting any email notification of help forum responses, is that correct?

[Alexmouse]

I've changed a setting in my control panel - so hopefully now I will be notified of your responses.