Problem with custom configuration

[strud]

I am using VGLCD V2.70 and I'm setting up a project to use my custom hardware.

Problem is, every time I go to save a custom setup, it sets the controller to a S1D13700 no matter what I do.

Is this a known problem ?

CS

[dejan.odabasic]

Hello,

Yes, this is a known problem, it will be corrected in next release of VisualGLCD.
You can manually configure the custom board xml file(using notepad) or if any of predefined configurations is using the same controller as you wish to use.
Selecting that configuration schema before choosing the custom(in dropdown menu) will save the controller of your choice.

Best regards.