Current Wish List
PulseIn?
On Sep 27, 2007;
On the first page of this thread;
Is the PulseIn really "done" as is indicated? Perhaps I am not looking in the right place.
That was more than two years ago!zristic wrote:PulseIn will be available very soon.
On the first page of this thread;
I have looked at the sound routine but can not see how that would work as a PulseIn.-- Pulse_In/Out routine (done as sound routine)
Is the PulseIn really "done" as is indicated? Perhaps I am not looking in the right place.
- mileta.miletic
- mikroElektronika team
- Posts: 493
- Joined: 05 Jun 2009 14:46
- Location: Belgrade, Serbia
- Contact:
Re: PulseIn?
Hi,
PulseIn function needs to use timers and interrupts, so it can't be part of library. We will provide the example for this function in some time, until then you can check Manchester example which use timers and interrupts to measure the length of the pulse
http://www.mikroe.com/forum/viewtopic.php?p=36740#36740
PulseIn function needs to use timers and interrupts, so it can't be part of library. We will provide the example for this function in some time, until then you can check Manchester example which use timers and interrupts to measure the length of the pulse
http://www.mikroe.com/forum/viewtopic.php?p=36740#36740
Regards,
Mileta
Mileta
Re: Current Wish List
well....SPI/ I2C bit bang interface: A hardware/ software combo which will allow rapid evaluation of target (application) IC's. The gui should be generic and should allow read and write to the devices.
Re: Current Wish List
Adding a fill option to GLCD_Rectangle would be nice, where the fill of the rectangle can be a selection of patterns (ASCII codes?) including blank and transparent, and the line could be either ON or OFF
This would greatly speed partial screen clears, as compared to using GLCD_Clear_Dot in nested X,Y loops.
This would greatly speed partial screen clears, as compared to using GLCD_Clear_Dot in nested X,Y loops.