Controlling the compiler from code

General discussion on mikroPascal PRO for PIC.
Post Reply
Author
Message
lgrfbs
Posts: 78
Joined: 25 Sep 2004 12:19
Location: Sweden - ADSL 0.5Mbps
Contact:
Contact lgrfbs

Controlling the compiler from code

#1 Post by lgrfbs » 25 May 2023 20:26

How to tell the compiler from code
which PIC and crystal speed you have built your PCB for?

Example:
Target: PIC16F874
Target speed: 4Mhz crystal
ICQ Mess. = Forums name as ref.
If you see stave/grammatical errors is you welcome too tell me.
Top
janni
Posts: 5373
Joined: 18 Feb 2006 13:17
Contact:
Contact janni

Re: Controlling the compiler from code

#2 Post by janni » 25 May 2023 21:05

This information cannot be controlled from code. It may only be set in IDE. Same goes for configuration words (single word in case of PIC16F874).
Top
lgrfbs
Posts: 78
Joined: 25 Sep 2004 12:19
Location: Sweden - ADSL 0.5Mbps
Contact:
Contact lgrfbs

Re: Controlling the compiler from code

#3 Post by lgrfbs » 25 May 2023 21:11

Thank you very much!
Then I know.
ICQ Mess. = Forums name as ref.
If you see stave/grammatical errors is you welcome too tell me.
Top
Post Reply

Return to “mikroPascal PRO for PIC General”