ready for pic bootloader

General discussion on mikroPascal.
Post Reply
Author
Message
gedza
Posts: 1
Joined: 22 May 2011 15:33

ready for pic bootloader

#1 Post by gedza » 27 Oct 2011 09:39

I'm experiencing a problem with the pic16f887 loaded with boot loader software.It is keeping Port D,5 on always every time but I need to use it for pwm .Even if I write a code which does not use d,5 it keeps on.Onother point if I use EASYPIC 6 to write the pic will be the bootloader software erased.
Top
User avatar
janko.kaljevic
Posts: 3565
Joined: 16 Jun 2011 13:48

Re: ready for pic bootloader

#2 Post by janko.kaljevic » 28 Oct 2011 09:11

Hello,

Please can you tell me your hardware configuration.
How did you connect chip to board or development system?

When you upload program to chip with EasyPIC6 on-board programmer it will override bootloader application.

Best regards.
Top
Post Reply

Return to “mikroPascal General”