ETHERNET ENC28J60 aplication do not pass Wireless netwok

[iste]

I have make a board with ATmega128A and ENC28J60 Ethernet.
IN the Local network (LAN) the comunication with my board is OK. The board is comunicating with a program that is running on my PC also response to "ping" from the same PC and other PC's on the LAN.

But when i try to access the board from wireless network, is not responding at all (PC software and Ping).

The wireless network is with Ubiquiti "Nanostation M5 loco" and is in bridge and WDS mode.
Also the wireless network works fine for other devices and PC's.

Please any idea?

[dejan.odabasic]

Hello,

I believe that we have the same correspondence on our support desk.
Without insight of complete network configuration it's hard to find the solution to this problem.

The easiest way to test, is to connect device to some other WiFi network (which use different network equipment).

Best regards.