viewtopic.php?f=72&t=78760
To do this I followed the tutorial in "HELP" mikroC for AVR which says (for read and write EEPROM):
Code: Select all
EEPROM_Write(0x150,adc); // Write some data at address 0x150 where adc is key
PORTB = EEPROM_Read(0x150); // Read data from address 0x150 and display it on PORTB
I analyzed EEPROM editor tool but there I see 16 boxes on the address? !!! All completed with "FF" ??? Let's say I go to address 0x150, how do I manually fill in the address so that it reads like number 125?
Later, I will have to write the eeprom file separate from the code in Atmega, right? And how do I do that with AVRFlash?
Please!