STM32F4 Discovery Shield and NECTO Studio v2.0

[mmessuri]

Sorry if I ma just missing it (must be old eyes) but when I am walking through the setup wizard of NECTO Studio v2.0 I cannot seem to locate a board configuration for the STM32F4 Discovery Shield. For my initial attempts at using the IDE I have selected Generic ARM Board; however, the mikroBUS count for this configuration is 0.

Could someone tell me if the use of the Discovery Shield is supported by NECTO and if so, which board configuration should be used (the actual development board I am using is the STM32F407G-Discovery which uses the STM32F407VG version of the MCU.

Thanks.

-- Michael --

[filip]

Hi,

Currently this board is not supported by NECTO Studio but we have in plans to support it in the future.

Regards,
Filip.

[mmessuri]

Thanks for the update. I will look at purchasing a different board.

-- Michael --