Hello.
Anybody use this programmer/debugger with Nucleo?
Maybe ME team has any small info/manual?
Best Wishes.
How to use Codegrip with Nucleo dev. boards?
Re: How to use Codegrip with Nucleo dev. boards?
Hi,
You should be able to connect it via the SWD connector, just make sure that it matches the pinout of the CODEGRIP,
Regards,
Filip.
You should be able to connect it via the SWD connector, just make sure that it matches the pinout of the CODEGRIP,
Regards,
Filip.
Re: How to use Codegrip with Nucleo dev. boards?
Hi,
I can make a simple pin to pin drawing if you don't manage to connect it properly.
Regards,
Filip.
I can make a simple pin to pin drawing if you don't manage to connect it properly.
Regards,
Filip.
Re: How to use Codegrip with Nucleo dev. boards?
Hello Filip.
Please do pin to pin drawing .
I have use everytime integrated ST-link, and now have WiFi Codegrip.
I know where to connect SWCLK and SWDIO and of course GND, but i need to connect reset and VCC.
VCC I can get from pin 1 of CN2.
Do I need to connect reset signal?? Best Wishes.
Please do pin to pin drawing .
I have use everytime integrated ST-link, and now have WiFi Codegrip.
I know where to connect SWCLK and SWDIO and of course GND, but i need to connect reset and VCC.
VCC I can get from pin 1 of CN2.
Do I need to connect reset signal?? Best Wishes.
Re: How to use Codegrip with Nucleo dev. boards?
Hello Filip.
Any response?
Any response?
Re: How to use Codegrip with Nucleo dev. boards?
Filip, where a simple drawing?
U promise to do it 1.5 years ago.
U promise to do it 1.5 years ago.