MIKROC Version 6 Vs Version 7
MIKROC Version 6 Vs Version 7
I have an odd quirk with version 7. I am using Mikroelectronicas programmer. If I use CTLR/F11 in version 6 the program loads and the PIC automatically starts. In Version 7.6 I have to interrupt power to restart the PIC. This is with a 16F877. I tried a PICKIT3 and ran into the same thing. The code being generated is slightly different making POR necessary.
Re: MIKROC Version 6 Vs Version 7
Hi,
Can you please explain this in details, it is really strange situation ?
Regards,
Filip.
Can you please explain this in details, it is really strange situation ?
Regards,
Filip.
Re: MIKROC Version 6 Vs Version 7
For some reason when code is generated in version 7.6 the PIC being programmed requires a POR to run. With the same C code but compiled with Mikroc version 6 the Pic starts after the programmer finishes automatically. In the case of V7 once the POR is done the code works fine. The PIC was a 16F877A.
Re: MIKROC Version 6 Vs Version 7
Hi,
This is the first time I heard of such issue.
Can you load both HEX files into the mikroProg Suite application to see if the POR is correctly set ?
Regards,
Filip.
This is the first time I heard of such issue.
Can you load both HEX files into the mikroProg Suite application to see if the POR is correctly set ?
Regards,
Filip.