easybee configuration for pic184520 and easypic6

General discussion on mikroC PRO for FT90x.
Post Reply
Author
Message
rmachemedze
Posts: 12
Joined: 20 Apr 2015 14:48

easybee configuration for pic184520 and easypic6

#1 Post by rmachemedze » 20 Apr 2015 15:13

hi there,

I am trying to configure two easybee modules as receiver and transmitter but it's not working. The lcd displays init takes up to 15s and init done but its not displaying mikroe easybee message which is sent via easybee. I have attached my codes which I am using..please help.
word receiver.docx
receiver
(15.52 KiB) Downloaded 146 times
word transmitter.docx,
word transmitter.docx
(14.89 KiB) Downloaded 157 times
Top
User avatar
Aleksandar.Mitrovic
mikroElektronika team
Posts: 1697
Joined: 11 Mar 2015 12:48

Re: easybee configuration for pic184520 and easypic6

#2 Post by Aleksandar.Mitrovic » 22 Apr 2015 16:25

Hi,

Can you tell me did you try this modules separately?
Or at the same time on the same board?

Note that you should open subject on corresponding topic page. This is provided for FT90x compiler.

Regards,
Aleksandar
Top
Post Reply

Return to “mikroC PRO for FT90x General”