Recent CO Clicks

[bkmtech]

I recently purchased some CO Clicks, and unlike the first set I bought about a year ago, the headers were already soldered to the board.

The reason this didn't work for me is I designed a small board with both a CO Click and an Air Quality Click.

To minimize width I placed them on both sides of the board.

To minimize the total depth of the boards I did not use a plug in header but soldered the headers to the board directly.

I have 2 headers next to each other with them staggered on opposite sides of the board.

Forum Shot.jpg (108.54 KiB) Viewed 18690 times

This works fine, but if the headers are pre-soldered to the Click board you can't access all 4 headers to solder them to the main PCB. You have to solder all 4 headers in place

Forum Shot 2.jpg (1.93 MiB) Viewed 18690 times

Forum Shot 3.jpg (1.81 MiB) Viewed 18690 times

[uros.cvetinovic]

Hi,

Can you please submit a ticket on our helpdesk regarding this subject:
http://helpdesk.mikroe.com/

Best regards,

Uros

[bkmtech]

Sure

bkmtech