Speakup Click [voice commands not being saved]

[ste]

I still don't understand about how to save commands onto the SpeakUp Click.
Uros has stated that "Every time you hit the "Upload project" button, the previously saved commands are erased"

I am trying to save the words "TWO SEVEN" and I am saying it slightly differently each time [to improve reliability]
I am saving each different Voice Command "TWO SEVEN" as 271 272 273 274 ... and so on ..
Each time I am assigning Pin IO7 to a 3 minute PULSE and pressing the Upload button
Are you saying that each time I press the UPLOAD button the previous "TWO SEVEN" recordings are erased ... ?
This is very confusing ... please clarify

[uros.cvetinovic]

Hi Stephen,

You are right, cause every time you press "Upload project" the application programs MCU on the SpeakUp click,
so it erases previously firmware on the MCU.

You should press "+" button, and add all commands to one project, and then upload it.

Best regards,

Uros