Voltage Options slider value wrong

General discussion on mikroProg™ programmer and debugger and mikroProg Suite software as well.
Post Reply
Author
Message
Dany
Posts: 3854
Joined: 18 Jun 2008 11:43
Location: Nieuwpoort, Belgium
Contact:
Contact Dany

Voltage Options slider value wrong

#1 Post by Dany » 09 Jul 2020 20:42

Reference: viewtopic.php?f=192&t=76927.

Ths same attentionpoint as in above link is valid for the 'slider' in 'Voltage Options'. There a value is shown that does not correspond with the actual value selected with the slider (always 27V).
The value becomes correct only after the 'slider' is moved.

It would be better if the slider always shows the correct value that will be sent to the PIC Vcc.

Thanks in advance.
Kind regards, Dany.
Forget your perfect offering. There is a crack in everything, that's how the light gets in... (L. Cohen)
Remember when we were young? We shone like the sun. (David Gilmour)
Top
User avatar
jovana.medakovic
mikroElektronika team
Posts: 986
Joined: 18 Dec 2018 10:36

Re: Voltage Options slider value wrong

#2 Post by jovana.medakovic » 10 Jul 2020 16:33

Hello,

Thank you for your suggestion.
I will forward it to our developer team for consideration.

Kind regards,
Jovana
Top
Dany
Posts: 3854
Joined: 18 Jun 2008 11:43
Location: Nieuwpoort, Belgium
Contact:
Contact Dany

Re: Voltage Options slider value wrong

#3 Post by Dany » 15 Jun 2021 18:39

No new version yet?
Kind regards, Dany.
Forget your perfect offering. There is a crack in everything, that's how the light gets in... (L. Cohen)
Remember when we were young? We shone like the sun. (David Gilmour)
Top
Post Reply

Return to “mikroProg™ programmer and debugger”