MikroProg suite slow to open

[ex-egll]

Hi, I am using Windows 10 with an i7 processor, SSD and 32Gb RAM. With MikroBasic 7.1, MikroProg 2.7 and the Easy PIC 7, when I compile and programme a chip it takes about 20 seconds fro MikroProg to open, is this normal?

If I start MikroProg from windows the start up time is closer to 30 seconds. It just seems excessively long, or am I just impatient?

ex-egll

[Hayato_U]

Hello,

My environment is almost the same. RAM is 16 GB.
The time from double-clicking on desktop shortcut to starting up was about 13 seconds.　(mikroProg Suite for PIC Ver.2.7)

[filip]

Hi,

Are you opening the mikroProg Suite from the IDE or by double-clicking its icon from the desktop ?

Regards,
Filip.

[ex-egll]

Thanks Hayato_U, so mine is a little slower!

filip, from the IDE it takes about 20 seconds, the desktop icon takes about 30 seconds

[ex-egll]

A quick update, installing v2.80 has made a vast improvement in startup time