MikroProg can not start Debugging Mode

[prakob]

Hi ME Team,

I faced problem of debugging PIC32MX250F128B, I can program chip with MikroProg but when i start to debug my code with hardware debugger which is mikroprog then i get notification windows like this



I can see that after i press "Start Debugger" then MikroProg was disconnected then become connect again (see at device manager) and Notification windows was popup at the same time.

please help

Kind regards

prakob

[filip]

Hi,

Did you try changing ICD channel and oscillator settings ?

Regards,
Filip.

[prakob]

Hello filip,
My board used default PGD1/PGC1 and it can not change channel because other channel were used for other circuit.

About frequency setting, my program run well so the frequency i set is absolutely correct.

Best regards.

prakob

[filip]

Hi,

I will check this and let you know.

Regards,
Filip.

[prakob]

Hello filip,

Could you find out my problem with mikroProg?

Kind Regards

prakob

[filip]

Hi,

I apologize for the inconvenience caused by this issue, it seems that there is a problem with this MCU and ICD.
I have forwarded this to our developers and as soon as I have any information I will contact you.

Regards,
Filip.