DEBUGGER MIKROPROG ICD - STEP INTO, OVER.. DOESN'T WORK

[robisonjunior]

I have been used the MikroProg Hardware (Mikro ICD) in mode debugger on MikroC Pro PIC and was every thing fine until now.

But I updated the MikroC Pro PIC to 3.5.0 and MikroProg Suit to 2.31 and I had problem in Debugger Mode.

When I Starter Debugger in MikroC Pro PIC the Step Into, Step Over, Step Out and Run to cursor doesn't work more. I can not press these buttons.

The PIC Software and Hardware are the same that I have been used. I do not changed nothing. The Oscilator is the same (XT - 4 MHz).

The Build + program is working normally.

The three leds red, orange and green of MikroProg Hardware (Mikro ICD) are lit.

The Blue Led blink when I press Run/Pause Menu but the debugger doesn´t Run. Nothing Happening !!

My configurations:

1- WINDOWS 7 64 BIT;

2- XT OSCILATOR 4 MHZ - NO PLL - NO USB

3- POWER TARGET IS FROM MY TARGET (5V);

Thanks,

Best Regards,

Robison Júnior

[marina.petrovic]

Hi,

I believe that my colleague answered you on this question via our support desk.

Best regards,
Marina

[yanoom]

Hi,
I realize it's been a long time, but I might be encountering the same issue...
Is it possible to post the resolution for this issue?

Thanks

[lana.arsic]

Hi,

Welcome to the MikroE forum.

Are you using the newest version of the compiler(7.1.0) and mikroProg Suite (2.51)?
Which MCU are you using?

Can you post the minimal project in a zip/rar archive
in which you have encountered this issue?

Kind regards,
Lana