Nucleo H743 and mikroProg for STM32 Problem

[RM65]

Hi all,
please, i need help using the Nucleo-144 (STM32H743ZI) with the mikroProg for STM32.

I use CN5 (MIPI connector) , GND Pin#3, SWDIO Pin#2 and SWCLK Pin#4 to connect to the programmer.

The board is powered via USB, than connect the programmer and reset the board as written in the documentation
of the Nuclwo Board (JP1, ST-Link-Reset). After that only the COM LED LD4 is red.

Starting the MikroProg (V1.61), Button "Detect MCU" results in the message "DEV_DFU_RUNNING_NOT_EXPECTED".

Is there anything else i have to consider/change when using the Nucleo Board?

Every help is highly appreciated.

Regards,
Ralf

[RM65]

Found some things....
1. Seems the message comes from the ST-Link V3, it is still connected to the Nucleo, the Link Reset is enabled (JP1)
2. mikroProg does not recognice/connect the programmer. I also dont see it in the SW (Pulldown Box?)
3. There is no message (if there is one) that it connected or not... Is this correct?

PS: USB driver is installed correct.

Regards,
Ralf

[stefan.filipovic]

Hi Ralf,

Please refer to section 6.3.2. of the following user manual:
https://www.st.com/resource/en/user_man ... ronics.pdf

Please check if the mikroProg firmware is up to date. You can do it using ST-Link Utility.

Kind regards,