PCB DESIGN FOR THE mikroProg for AVR PROGRAMMER

General discussion on mikroProg™ programmer and debugger and mikroProg Suite software as well.
Post Reply
Author
Message
jose_pic16f887
Posts: 26
Joined: 10 Sep 2018 11:08

PCB DESIGN FOR THE mikroProg for AVR PROGRAMMER

#1 Post by jose_pic16f887 » 20 Oct 2019 23:21

greetings companions of the forum, I have designed an experimental prototype to record the different families of the Avr Type Dip, using the mikroProg for Avr, I have connected the different pins such as Reset, Mosi, Miso, SCK, VCC, GND, the 5Vdcc come directly from the mikroProg for Avr and will give power to the 5 bases of the avr plus the 4 programming connections of the avr, this is just an experimental design and I'm just going to try the electronic circuit.
well I hope your comments to continue improving the design

Thank you
:wink:
Joseph
Attachments
PROGRAMMER OF AVR.pdf
(63.5 KiB) Downloaded 85 times
Top
jose_pic16f887
Posts: 26
Joined: 10 Sep 2018 11:08

Re: PCB DESIGN FOR THE mikroProg for AVR PROGRAMMER

#2 Post by jose_pic16f887 » 29 Oct 2019 16:19

Hello friends, I told you I already found the solution, I had to download a library of the proteus and I already have the desired connector, attached the images and the pcb of the circuit to program the avr

:wink:

jose
Attachments
PROGRAMMER AVR VERSION 6_page-0001.jpg
PROGRAMMER AVR VERSION 6_page-0001.jpg (166.58 KiB) Viewed 1276 times
PROGRAMMER OF AVR CIRCUIT VERSION 2.jpg
PROGRAMMER OF AVR CIRCUIT VERSION 2.jpg (107.94 KiB) Viewed 1276 times
PROGRAMMER OF AVR VERSION 2.jpg
PROGRAMMER OF AVR VERSION 2.jpg (77.3 KiB) Viewed 1276 times
Top
Post Reply

Return to “mikroProg™ programmer and debugger”