Viewing register values by mikroprog

[jalal_am]

Hi all.
I am working with dspic33ep family, the MC_PWM suddenly hangs after about 25 minutes. for debugging purpose, I would like my MCU works like release mode and I be able to see values after the problem pops up. How is it possible in debugging mode? in debugging mode I am able to run at most 1 cycle.
I would be grateful if you share your comments.
Regards,

[danilo.milovic]

Hi,

when you enter debug by pressing F9, then press F6, if none of breaking points were selected the MCU will run like in release mode,

when PWM hangs you can pause by pressing F6 again and then you will be able to see desired values.

Regards,

Danilo

[jalal_am]

Hi, Thank you for your response.
Many times when I push pause button in debugging mode it gives the error "can not call device parameters" and it did not shows register values. Could you please advise me what could be wrong?

thank you