Mikroe programmer with STM32H743,STM32H750

[simonsayz]

Hello ...

some question about Mikroe programmer

Q1. Programmer connection
should be 5 pins ( TMS,TCk,TDI,TDO,TRST ) ?
or Can be 3 pins ( SWD,SWClk, GND ) ?

Q2. Is Support STM32H7xx ?

Thanks

[jovana.medakovic]

Hello,

1. You can use TMS, TCK, TDO, TDI, TRST, #RESET lines for JTAG programming or SWDIO, SWCLK lines for SWD (Serial Wire Debug) programming.

2. Yes, our programmer for STM supports STM32H7xx MCUs.

Kind regards,
Jovana

[simonsayz]

Thanks for fast answer.

Connection
SWDIO,SWCLK,GND (3wire used)

Mikroe Programmer : Firmware update

ST-LINK SN : 49FF6B065067545618390687
ST-LINK FW : V2J36S0
Voltage : 3.03V
SWD freq : 4000 KHz
Connect mode: Under Reset
Reset mode : Hardware reset
Device ID : 0x450
Device name : STM32H7xx
Flash size : 2 MBytes
Device type : MCU
Device CPU : Cortex-M7

1. mikroProg v1.61
slow but, it works fine

2. Pascal
Menu->Tools->Programmer/Debugger Options
Tab : prog/debug selection : [enabled]
Tab : debug start-up options : [disabled]

start debug using "F9"

It works only software debugger , not hardware debugger....
(STM32CubeIDE v1.3.0 : It works fine using mikroE Programmer)

How to solve this ?

-------------------------------------------------------------------------
Oh...Sorry ... My mistake

Menu->Edit->Edit Project->Build Type-> Debug

Solved

Thanks again.