Hello ...
some question about Mikroe programmer
Q1. Programmer connection
should be 5 pins ( TMS,TCk,TDI,TDO,TRST ) ?
or Can be 3 pins ( SWD,SWClk, GND ) ?
Q2. Is Support STM32H7xx ?
Thanks
Mikroe programmer with STM32H743,STM32H750
- jovana.medakovic
- mikroElektronika team
- Posts: 986
- Joined: 18 Dec 2018 10:36
Re: Mikroe programmer with STM32H743,STM32H750
Hello,
1. You can use TMS, TCK, TDO, TDI, TRST, #RESET lines for JTAG programming or SWDIO, SWCLK lines for SWD (Serial Wire Debug) programming.
2. Yes, our programmer for STM supports STM32H7xx MCUs.
Kind regards,
Jovana
1. You can use TMS, TCK, TDO, TDI, TRST, #RESET lines for JTAG programming or SWDIO, SWCLK lines for SWD (Serial Wire Debug) programming.
2. Yes, our programmer for STM supports STM32H7xx MCUs.
Kind regards,
Jovana
Re: Mikroe programmer with STM32H743,STM32H750
Thanks for fast answer.
Connection
SWDIO,SWCLK,GND (3wire used)
Mikroe Programmer : Firmware update
1. mikroProg v1.61
slow but, it works fine
2. Pascal
Menu->Tools->Programmer/Debugger Options
Tab : prog/debug selection : [enabled]
Tab : debug start-up options : [disabled]
start debug using "F9"
It works only software debugger , not hardware debugger....
(STM32CubeIDE v1.3.0 : It works fine using mikroE Programmer)
How to solve this ?
-------------------------------------------------------------------------
Oh...Sorry ... My mistake
Menu->Edit->Edit Project->Build Type-> Debug
Solved
Thanks again.
Connection
SWDIO,SWCLK,GND (3wire used)
Mikroe Programmer : Firmware update
ST-LINK SN : 49FF6B065067545618390687
ST-LINK FW : V2J36S0
Voltage : 3.03V
SWD freq : 4000 KHz
Connect mode: Under Reset
Reset mode : Hardware reset
Device ID : 0x450
Device name : STM32H7xx
Flash size : 2 MBytes
Device type : MCU
Device CPU : Cortex-M7
1. mikroProg v1.61
slow but, it works fine
2. Pascal
Menu->Tools->Programmer/Debugger Options
Tab : prog/debug selection : [enabled]
Tab : debug start-up options : [disabled]
start debug using "F9"
It works only software debugger , not hardware debugger....
(STM32CubeIDE v1.3.0 : It works fine using mikroE Programmer)
How to solve this ?
-------------------------------------------------------------------------
Oh...Sorry ... My mistake
Menu->Edit->Edit Project->Build Type-> Debug
Solved
Thanks again.
- Attachments
-
- scr01.png (24.33 KiB) Viewed 2121 times