STM32F103C8 HID USB SUPPORT!!!

[jodybotha@yahoo.ca]

Hi Team
As per a post I read earlier on in the forum
apparently the STM32F103C8 USB HID library should be complete? as previously mentioned in the forum by one of the members of the Team that it will be ready in a few weeks well that was in may 2017 approximately 7 months ago
I am getting very mad as i am getting very little satisfaction for my large investment
However i will give the Mikroe team the benefit of the doubt!
So I will be nice, can i please have the HID USB library for the STM32F103C8 for Mikrobasic pro for ARM?
Thank you inadvance
Regards Jody

[lana.arsic]

Hi Jody,

If you are referring on USB library inside compiler,
in that library STM32F103 is supported, do you have any issue with that library?

If you are referring on USB Device Library, as my colleague has answered in May 2017 here,
STM32F103 unfortunately is not supported, because MCU doesn't have OTG functionality which is used in the library.

Kind regards,
Lana

[jodybotha@yahoo.ca]

Hi Lana
Thank you for responding
your reply has left me very confused
Just to clear things up perhaps i made a mistake
please answer me this
can i use the STM32F103C8 with microbasic pro for arm compiler USB library for an HID application? IE a hid mouse?
i am not sure what the difference is between USB device lib and the usb lib? i know that the device does not support OTG
i received millions of errors the last time i tried however this could have been for many reasons
thank you kindly
Regards jody

[jodybotha@yahoo.ca]

Hi Lana
I must formally apologize
I see it does compile however
the usb device library that was installed must be unselected
or it creates huge errors so just to clarify to every one whom has made this mistake
yes the STM32F103XX usb library will work for HID applications
best regards
Jody