Hello,
It is a raining day here in Germany, I am just starting up a Nucleo-F411RE board, I am traying to find for some example for the ADC and UART but I don't find much in the example for this board.
The clock setting is also a bit hard and not easy to released the PLL setting, the simplest example I tried (blink a led) has some off time issue.
Perhaps somebody already faced the same issue and would like to share some info.
Kind regards
Davide
STM32F411RE-Nucleo 64
- filip.grujcic
- Posts: 822
- Joined: 14 May 2018 08:34
Re: STM32F411RE-Nucleo 64
Hi Davide,
Please find attached ADC and UART examples, as well as some configuration schemes.
Please note these were written for our MCU Card 29 for STM32, so some modifications according to your hardware might have to be made.
Kind regards,
Please find attached ADC and UART examples, as well as some configuration schemes.
Please note these were written for our MCU Card 29 for STM32, so some modifications according to your hardware might have to be made.
Kind regards,
- Attachments
-
- examples.zip
- (380.86 KiB) Downloaded 64 times
-
- config_schemes.zip
- (2.95 KiB) Downloaded 69 times
Filip Grujcic
Re: STM32F411RE-Nucleo 64
Hello Filip,
Thanks for your replay, It seams the example are in C, do you have the same example in miKroBasic?
Thanks
Davide
Thanks for your replay, It seams the example are in C, do you have the same example in miKroBasic?
Thanks
Davide
- filip.grujcic
- Posts: 822
- Joined: 14 May 2018 08:34
Re: STM32F411RE-Nucleo 64
Hi Davide,
We only have these examples in mikroC, but I have translated them to Basic just for you.
Kind regards,
We only have these examples in mikroC, but I have translated them to Basic just for you.
Kind regards,
- Attachments
-
- test.rar
- (64.65 KiB) Downloaded 74 times
Filip Grujcic
Re: STM32F411RE-Nucleo 64
Hello Filip,
Thanks for your effort , I had to modify the clock setting and minor changes (ADC reads every 500ms).
I share a working ADC example and data sent to UART with my Nucleo-64 board STM32F411RE.
Best regards
Thanks for your effort , I had to modify the clock setting and minor changes (ADC reads every 500ms).
I share a working ADC example and data sent to UART with my Nucleo-64 board STM32F411RE.
Best regards