MikroBasic debug mode problem

General discussion on mikroBasic PRO for ARM.
Post Reply
Author
Message
Alessandro Fulignani
Posts: 101
Joined: 04 Nov 2016 13:09

MikroBasic debug mode problem

#1 Post by Alessandro Fulignani » 17 May 2020 20:36

Good evening,

During debug, if i try to manually change a register of the UART0 i get en error message( Read IDHCSR Fail) and then i have to restart the debug session.(See the attached picture)

I did see the problem with UART0_S1, UART0_D,UART0_C2....

But i think that the problem happens with other registers.

Do you have any suggestion?

Regards,

Alex
Attachments
Annotation 2020-05-17 212958.png
Annotation 2020-05-17 212958.png (191.69 KiB) Viewed 1374 times
Top
User avatar
filip
mikroElektronika team
Posts: 11874
Joined: 25 Jan 2008 09:56

Re: MikroBasic debug mode problem

#2 Post by filip » 29 May 2020 13:45

Hi,

Can you please attach the minimal project that demonstrates this issue ?

Regards,
Filip.
Top
Post Reply

Return to “mikroBasic PRO for ARM General”