Nucleo H743 and mikroProg for STM32

General discussion on mikroC PRO for ARM.
Post Reply
Author
Message
RM65
Posts: 8
Joined: 03 May 2020 13:43

Nucleo H743 and mikroProg for STM32

#1 Post by RM65 » 09 May 2020 13:30

Hi all,
please, i need help using the Nucleo-144 (STM32H743ZI) with the mikroProg for STM32.

I use CN5 (MIPI connector) , GND Pin#3, SWDIO Pin#2 and SWCLK Pin#4 to connect to the programmer.

The board is powered via USB, than connect the programmer and reset the board as written in the documentation
of the Nuclwo Board (JP1, ST-Link-Reset). After that only the COM LED LD4 is red.

Starting the MikroProg (V1.61), Button "Detect MCU" results in the message "DEV_DFU_RUNNING_NOT_EXPECTED".

Is there anything else i have to consider/change when using the Nucleo Board?

Every help is highly appreciated.

Regards,
Ralf
Top
User avatar
stefan.filipovic
mikroElektronika team
Posts: 1135
Joined: 18 Dec 2018 10:30

Re: Nucleo H743 and mikroProg for STM32

#2 Post by stefan.filipovic » 12 May 2020 11:04

Hi Ralf,

I believe that you have been answered here:
viewtopic.php?f=192&t=76670&p=305616#p305616

Kind regards,
Stefan Filipović
Top
Post Reply

Return to “mikroC PRO for ARM General”