I have an LV32MXv6 development board, and mP32, 1.80. I wrote a program, selected ICD on the project setting, downloaded, and then when I went to turn the ICD on I got an error box that said "mikroICD: -error starting debugger - firmware doesn't exist". After closing that box, I got another one saying "mikroElektronika ICD hardware not found".
Is there a flaw in the v6 firmware, or what does this mean?
Oddly, when I set the project settings to ICD, leds B6 and 7 glow dimly, but the diagram for the LV32MXv6 show ICD connected to B0 and 1.
MikroICD
- slavisa.zlatanovic
- mikroElektronika team
- Posts: 1321
- Joined: 07 Apr 2009 09:39
Re: MikroICD
Hi!
Please, tell me which hardware revision (HW REV) is your LV32MX v6 development board?I have an LV32MXv6 development board,...
Best regards
Slavisa
Slavisa
Re: MikroICD
On the back, it says "HW REV. 1.01" under the logo.
If you know what you're doing, you're not learning anything.
Re: MikroICD
Hi I have the same Board and vertion and have the same problem.
I have tried several of the examples and the ICD works ok.
But if I use VTFT V1.30 to draw a simple screen I get this error.
However if I try the Calculator Example the ICD works ok. I suspect this was done in the older vertion of VTFT.
Hope we get to the bottom of this isue as I will be doing a lot of VTFT and debuging....
I have tried several of the examples and the ICD works ok.
But if I use VTFT V1.30 to draw a simple screen I get this error.
However if I try the Calculator Example the ICD works ok. I suspect this was done in the older vertion of VTFT.
Hope we get to the bottom of this isue as I will be doing a lot of VTFT and debuging....
Re: MikroICD
Found this on another post and solved the isue with me...
Thanksin Edit Project window, change ICE/ICD Comm Channel Select to : ICE EMUC1/EMUD1 pins sahred with PGC1/PGD1.