As an owner of MINI32MZ board have a question which puzzles me from the very beginning - what is the logic of pin names provided in the manual?
For example:
- pins RD4 RD5 are shown as UART0 while there is no such UART# neither in the device no in compiler. Moreover the only UART which can be mapped to the pins is UART2;
- pins RF4 RF5 are shown as I2C while it could be only I2C5;
- pins which are marked as SPI1 cannot be mapped with SPI1 - only with SPI2 (due to the fact that RG6 - SCK is fixed as SCK2 and cannot be remapped) etc.