Can I use Pickit3 on SmartGLCD240x128 Board?

General discussion on Visual GLCD Software.
Post Reply
Author
Message
micomz
Posts: 1
Joined: 02 Dec 2014 02:52

Can I use Pickit3 on SmartGLCD240x128 Board?

#1 Post by micomz » 28 Feb 2015 04:48

Hello.

I using the SmartGLCD240x128_hw_rev_1.51 and mikroC PRO for PIC.
And I download the Hex file by SmartGLCD 240x128 18F87K22 Bootloader. (Because I have no mikroProg.)
But I want to use Microchip Pickit3 Programmer instead of bootloader for downloading the Hex file .
Can I use Pickit3 or ICD3 Programmer on SmartGLCD240x128_hw_rev_1.51 Board?
What should I do if possible?

Thanks.
Top
User avatar
darko.minic
Posts: 747
Joined: 01 Dec 2014 11:10

Re: Can I use Pickit3 on SmartGLCD240x128 Board?

#2 Post by darko.minic » 01 Mar 2015 15:26

Hi,

Welcome to mikroE forum.

You can download .hex file on your SmartGLCD 240x128 via Pickit3 programmer.
For that purpose you can use connector CN3 on SmartGLCD 240x128 board.
Also you should pay attention on pinout (program lines: PGC, PGD, MCLR, VCC, GND) on Pickit3 programmer and SmartGLCD 240x128 board as well.

Regards,
Darko
Top
Post Reply

Return to “Visual GLCD General”